Copy column CNA from Aero Table

At this point you should have two projectiles open. You should have the spinner model with the locked body fixed aeros open. You should also have the model with the forward canards open.

Make sure the spinner model with the locked body fixed aeros is the active model.

Please do the following:

Open "Aero Direct Input" which is found in the Analysis menu under Aerodynamics
Go to the "Basic Aeros" tab
Click the "CNa" heading which will highlight the column
Click the Copy Icon. The copy icon is in the task menu. It looks like two sheets of paper.
Click OK on the pop-up message

The screen capture below highlights the process.