This tutorial provides an introduction to G&C, and takes you through several
tasks which provide an overview of how to use the PRODAS/G&C environment to
its fullest.
You will learn how to:
- Open the Flight Control System Builder from inside the G&C module of PRODAS
- Generate a Flight Control System Block Diagram
- Connect the Flight Control System to a Projectile
- Simulate the trajectory of a Projectile with an active Flight Control System
- Plot internal variables within the Flight Control System during system simulation
- Plot the trajectory of a Projectile with an active Flight Control System
- Plot the trajectory of a Projectile the Flight Control System turned off
- Cross plot the results of the two simulations
G&C installation and configuration
This tutorial assumes that you have successfully installed PRODAS with the
G&C optional module on your computer and received a free evaluation key, or
are a registered user of PRODAS and G&C.
The evaluation version of PRODAS includes the G&C analysis. It is fully functional but time-limited to
30 days.
Tutorial example files
The tutorial projectile file is available in the ...\ ProdasV3\ProjectileData\GandCExamples
folder. If you want to follow along
and start with a model without the Flight Control System Block Diagram already
built then use ...\ProdasV3\ProjectileData\LargeCal\#105M735Cartridge.pr3
| …\ProdasV3\ProjectileData\LargeCal\#105M735Cartridge.pr3 |
Projectile with no flight control system (FCS) defined |
| ...\ProdasV3\ProjectileData\Examples\GandCExamples\105M735Cartridge.pr3 |
Projectile with example FCS system |
Top
Next